Cable Stiff Leg Deadlift

The Cable Stiff Leg Deadlift primarily works the Erector Spinae, Gluteus Maximus, with secondary activation of the Adductor Magnus, Biceps Femoris (Long Head), Erector Spinae, Gluteus Maximus and stabilizer support from the Latissimus Dorsi, Levator Scapulae, Rectus Femoris, Rhomboids, Trapezius (Lower), Trapezius (Middle), Trapezius (Upper). It is a cable compound exercise at intermediate difficulty.

The Cable Stiff Leg Deadlift is a intermediate compound exercise performed with cable, following a hinge movement pattern. It primarily targets the Erector Spinae, Gluteus Maximus, with secondary engagement of the Adductor Magnus, Biceps Femoris (Long Head), Erector Spinae, Gluteus Maximus. This is a bilateral pulling movement, engaging both sides of the body simultaneously.

A cable compound pull exercise targeting the Erector Spinae and Gluteus Maximus.

EquipmentCable
DifficultyIntermediate
TypeCompound
MovementHinge
ForcePull
LateralityBilateral
PrimaryErector Spinae, Gluteus Maximus
SecondaryAdductor Magnus, Biceps Femoris (Long Head), Erector Spinae, Gluteus Maximus

Muscles Worked

Front
Back
Primary Secondary Stabilizer

The Erector Spinae, and Gluteus Maximus are the primary movers, collectively driving the movement and absorbing the greatest share of the load. The Adductor Magnus, Biceps Femoris (Long Head), Erector Spinae, and Gluteus Maximus act as secondary movers, assisting the primary muscles and contributing meaningfully to the overall output. The Latissimus Dorsi, Levator Scapulae, Rectus Femoris, and 4 other muscles act as stabilizers, maintaining joint position and postural alignment throughout the movement.

Primary Muscles

Secondary Muscles

Stabilizer Muscles

How to Perform

Preparation

  1. Stand between two very low pulleys with shoulder width or narrower stance.
  2. Squat down and grasp stirrup attachments to each side.
  3. Stand upright with arms straight down to sides.

Execution

  1. Bow forward by bending hips.
  2. Bend knees slightly during descent and keep waist straight, flexing low back at bottom.
  3. With knees slightly bent, raise torso by extending at waist, then hips, gradually extending knees until standing upright.
  4. Pull shoulders back slightly if rounded.
  5. Repeat.

Comments

  1. Lower back may bend slightly during hip flexion phase.
  2. Erector Spinae is exercised isometrically if low back does not articulate as withStraight Back Stiff Leg Deadlift(targeting Glutes).
  3. Begin with light weight and add additional weight gradually to allow adequateadaptation.
  4. Throughout lift, keep arms straight.
  5. Knees can be kept bent throughout movement.
  6. Do not stand behind pulleys.

Tips & Common Mistakes

Programming Suggestions

Adapt your sets and reps to your training goal.

Strength3–5 sets × 3–6 reps at 80–90% 1RM with 2–4 minutes rest.
Hypertrophy3–5 sets × 6–12 reps at 65–80% 1RM with 60–120 seconds rest.
Endurance2–4 sets × 15–20 reps at 50–65% 1RM with 30–60 seconds rest.

Alternative Exercises

These exercises target the same primary muscles (Erector Spinae, Gluteus Maximus) and can be substituted based on your equipment or variation preferences.

Get this data via the REST API or MCP Server.